|
|
1. |
Strip off the old finish with Pioneer's Flash
stripper diluted at 32 ounces per gallon ( 1 : 4 ) of cold water
into a mop bucket. |
|
|
2. |
When stripping a floor, work on
one manageable section at a time. Apply Flash with a fully
loaded mop flooding the floor with stripping solution. |
|
|
3. |
Give Flash 3 - 5 minutes to work before you
start to scrub. If the floor dries before the 10 minutes are up,
re-wet the area. |
|
|
4. |
Use a scrubbing tool to scrub the edges and
hard-to-reach areas. Scrub the rest of the floor with the
low-speed scrubber and pick up the solution with a Wet Vacuum. |
|
|
5. |
Flood rinse the floor with clear water and
pick that up with a Wet Vacuum. Finally, damp mop with clear water
and let the floor air dry. Once the floor is dry, you're ready to
apply the 4 coats of finish. |
|
|